Hickson Decor^® Plus Wood Stain

• 

  Warm Grey *

• 

  Antique pin

• 

  Tanalith Green *

• 

  Natural

• 

  Walnut

• 

  Light

• 

  Chestnut

• 

  Western*

• 

  Teak

• 

  Olive *

• 

  Tanatone Brown

• 

  Calif

• 

  Rosewood

• 

  Burma

• 

  Jade *

• 

  Creol

• 

  Ebon *

Warning

Используемое количество:

• 1 л покрывает 6-7 м2 в 2 слоя

Surface Preparation:

• Remove any dirt, oil and wood dust from the surface.
• New Wood Surfaces:
  • Sand the surface with sandpaper #80/120.
  • Thoroughly clean the generated dust.
• Old Uncoated Wood Surfaces:
  • Sand the weathered surface with sandpaper #80/120.
  • Thoroughly clean the generated dust.
• Coated Wood Surfaces:
  • Do not apply the product directly on pre-coated surfaces.
  • Remove the old paint/varnish from the surface completely with a sandpaper.
  • Thoroughly clean the generated dust.

Application:

• The product is ready to use and does not require thinning.
• Stir the product thoroughly before use and check its homogeneity. Repeat this process during the application.
• Apply the product in 2 coats by brush and wait 24 hours between coats.
• Perform a slight sanding with sandpaper #180/220 between coats.
• Wait 24 hours for complete dry.
• Apply in the direction of wood grain to get a homogeneous look.

Maintenance (when the same product had been used before):

• Do not apply the product directly on pre-coated surfaces.
• Clean the wood surface completely from dirt and oil and perform a slight sanding.
• Thoroughly clean the generated dust.
• Repeat same process as described in “Application” with 1 or 2 coats depending on weathering.
• Inspect annually and maintain as required.

Instructions:

• FOR EXTERIOR USE ONLY.
• NOT SUITABLE FOR FLOORINGS.
• Keep product closed when not in use.
• The general application temperature of the product is between 15oC to 25oC at a relative humidity range of 40-65%.
• The moisture content of the wood should be max. 20%.
• Do not apply the product under direct sunlight or rain.
• Do not apply linseed oil, basecoat/primer, yacht varnish before or after Hickson Decor^® Plus Wood Stain applied surfaces.
• To provide a long lifetime protection against decay, apply HEMEL Timbercare Aqua on untreated softwoods and wait 24 hours before applying Hickson Decor^® Plus Wood Stain.
• The product should be stored at temperatures between 5°C to 35°C.
• Painting tools should be cleaned with mineral spirits after the application.

Safety Precautions:

• USE WITH ADEQUATE VENTILATION.
• KEEP OUT OF REACH OF CHILDREN.
• Do not transfer contents to other containers for storage.
• Do not use empty plastic cans for other purposes.
• To avoid overexposure, open windows and doors or use other means to ensure fresh air entry during application and drying.
• Avoid contact with eyes and skin.
• Wash hands after using.
• FIRST AID: In case of eye contact, flush thoroughly with large amounts of water. Get medical attention if irritation persists. If swallowed, call Poison Control Center, hospital emergency room, or physician immediately.
• Dispose of contents/plastic cans in accordance with national regulations.
• Please refer to the Safety Data Sheet (SDS) of the product for health and safety information.