Hemel Acrylic Filler Paste Teak (506)

• 1 L. covers 6-7 m² with two coats

Surface Preparation:

• Remove any dirt, oil, and wood dust from the surface.

New Wood Surfaces:

• Surface must be dry, clean, and free of oil/dust.
• For new wood surfaces: sand with 80/120 grit sandpaper and remove dust.

Old Uncoated Wood Surfaces:

• For old unpainted/unvarnished wood: prepare the surface smoothly.
• For painted/varnished surfaces: completely remove existing coatings by sanding.

Coated Wood Surfaces:

• Do not apply the product directly on pre-coated surfaces.
• Remove the old paint/varnish from the surface completely with sandpaper.
• Thoroughly clean the generated dust.

Application:

• Product is ready-to-use, no dilution required.
• Apply into cracks, gaps, and defects with a spatula.
• For deep gaps, apply several thin layers instead of a single thick layer, allowing each coat to dry.
• After full drying, sand the surface and apply paint or varnish if desired.

Maintenance (when the same product had been used before):

• Do not apply the product directly on pre-coated surfaces.
• Clean the wood surface completely from dirt and oil and perform a light sanding.
• Thoroughly clean the generated dust.
• Repeat the same process as described in “Application” with 1 or 2 coats depending on weathering.
• Inspect annually and maintain as required.

Instructions:

• FOR EXTERIOR USE ONLY.
• Not suitable for flooring applications.
• Close the lid tightly after use.
• Application temperature: 10–25°C, relative humidity: 40–65%.
• Moisture content of wood should be below 20%.
• Do not apply under direct sunlight or in humid/rainy environments.
• Store between 5–30°C, protect from frost.
• Clean tools with water after application.